AU LEDK15   4 x 15mm LED Marker Light Kit   IP66

This kit contains 4 Round IP66 LED fittings (see spec for LED015 below) each with 5m of cable and an indoor plug-in transformer c/w a 10 way junction box and 10m of cable.
Additional LED fittings (LED015 see below) are available to add to the system and with the use of an extra slave junction box (LEDS001) an further 10 fittings can be added.

AU LEDK15 LED Marker Light Kit - £39.95

AU LEDS001 Slave Junction Box - £12.95

AU LED015   15mm LED Marker Light     IP66

This LED015 LED marker light contains one super bright 0.12w white LED.

It comes c/w 5 metres of cable and is designed for use with an AC 12volt toroidal transformer or as an extra item to the LEDK15 Kiit as shown above.
The LED is non dimmable with a Stainless Steel Finish.

Cut Out : 10mm     Diam : 15mm     Recessed Depth : 35mm     Weight : 0.01Kg

AU LED015 LED Marker Light - £6.95

SL9925 Set of 10 IP65 LED Walkover Lights ~ Stainless Steel

This kit contains 10 walkway lights each prewired with 2m of rubberised flex, an IP rated external transformer wit a 5m mains lead and all the screw fit connectors required for a very simple waterproof installation. Extension cables at 4m and 6m are also available.

The walkover fittings each have three 0.1watt LEDs. Rated at IP65 with Polished Chrome Bezels
They are ideal for Decking, Patios, Pathways or for Bathrooms including Zones 1 and 2
Available with White or Blue LEDs

Diam. of top : 35mm    Depth : 25mm    Cutout: 25mm

SL9925 Set of 10 IP65 LED Walkover Lights - £85.00

CA4 - 4m extension cable - £5.60

CA6 - 6m extension cable - £7.25

The extension cables add to the 2m lead from each fitting.
This allows a fitting to be located upto 6m or 8m from either of the 5 way connectors

Click here to enlarge layout diagram

Kit comprises of 6 CLI-LED010's as above
Plug-in Transformer (not IP rated)
20m Cable plus easy snap fit connectors for each light
Diam. of top : 50mm  Cut Out: 41mm   Depth : 66mm 

The Transformer must be sited indoors or within a suitable waterproof housing.
The waterproof connectors easily clamp onto the cable and can be positioned any distance apart.
The LED's emit little or no heat and the 12volt supply Safe Extra Low Voltage makes this system ideal for gardens and decking areas. Kits available with either white or blue LEDs

Blue £79.95     White £83.50

Everything needed for an easy installation of a 6 light walkway set.Stainless Steel LED Lighting heads pre-wired with 2m cable and connected by simple snap-fit connectors onto 20m length of cable powered by a single transformer.

Upto 6 additional LED walkover lights can be fitted to the cable and powered by the transformer supplied. Each individual walkover light is fitted with a 0.8m lead allowing great flexibility in planning layouts.

C LED020 / 022 IP65 LED Walkover Light
5LED 12volt 0.8watt LED compact walkway light
Durable Aluminium Bezel   Rated at IP65
Ideal for Decking, Patios and Pathways - wire in parallel

Aluminium casing c/w LED's   Available with White or Blue LED
For use with an external constant voltage 12v DC transformer

These compact LED lights are suitable for use as wall or floor lights, indoors or outdoors. The low heat output makes this fitting suitable for use in the heaviest traffic areas as ambient lighting or as marker lights etc

Square C LED022Diam. of top : 50 x 50mm  Cut Out: 38mm   Depth : 40mm

Round C LED020 Diam. of top : 50mm  Cut Out: 38mm   Depth : 40mm 

Blue £9.06    White £9.45

S SL008 Spot
The SL008 low profile groundlight comes c/w a 1watt high power luxeon LED. It can be used as a step light, ground light or down light in interior, exterior or submerged situations.Made of marine grade stainless steel (316) it has a 5mm toughened walkover clear glass. It is sealed for life acheiving an IP68 submersible rating. It comes c/w 1m of red and black teflon cable. To be used in conjunction with a constant current LED driver - see below. Wire in series.
SL008 Spot , 15° lens, 210 lm at 1m

LED's available in white or blue
Diameter of top : 32mm   Depth : 28mm   Cut out : 26mm

£32.50

S LED TRISTAR MASTER RGB COLOUR CHANGING LAMP

This LED TRISTAR is a high power 5watt Cree MR16 LED unit fitting most MR16 fittings.
Using on board chip technology it is operated with the TRISTAR Remote - see below.

It can be wired up to 32 Slave lamps - see below.
By pointing the Remote at the Master lamp all Slave lamps change colour simultaneously.

To be used in conjunction with a constant voltage LED driver - see below.
50 mm x 52mm     Lip 2.4mm Power consumption 5 watts   Wire in Parallel

£64.50 

S LED TRISTAR SLAVE RGB

To be used in conjunction with a constant voltage LED driver - see below.
50 mm x 52mm     Lip 2.4mm Power consumption 5 watts   Wire in Parallel

£48.50

EMC-GULED
240volt 50mm 2watt GU LED Lamp

These lamps can be used with any GU fitting
e.g. the EMCGU10 walkover/driveover fitting see Recessed Groundlights

Available White, Blue, Green, Yellow or Red

EMC-GULED £6.95

AU LED09 IP
IP68 Rated - Constant Current LED driver for use with 350mA LED's

Protected against submersion in water (up to 2m)   350mA Constant current output
Suitable for the supply of 1-9 1W LED's  Overload protection   Short-circuit protection
Thermal protection   Pre-wired 1m primary lead   Pre-wired 0.5m secondary lead
1.0kV SURGE PROTECTION – EN 61547   Safety compliance - EN 61347
EMC compliance - EN 55015, EN 61000, EN 61547
Non-dimmable   Series wiring only   3 Year guarantee

LEDs should be wired in series to this power supply.

Length : 118mm   Width : 33mm   Height: 25mm
£16.95

AU LED16 IP
IP68 Rated - Constant Votage LED driver for use with 12volt LED's

For the supply of low voltage LED lamps
IP68 rated - suitable for use in pond/pool & outdoor LED lighting
Protected against submersion in water (up to 2m)
Short circuit protection   Thermal protection   12V DC output
Pre-wired 100cm primary lead   0.5m secondary lead
1.0kV SURGE PROTECTION – EN 61547
Safety compliance – EN 61347   EMC compliance – EN 55015, EN 61000, EN 61547
Non-dimmable   Parallel wiring only   3 Year guarantee
* NB - when used with MR8 LED lamps - minimum of 2 lamps

LEDs should be wired in parallel to this power supply.
Length : 118mm   Width : 36mm   Height: 25mm
£16.95